Thank you for your replies, I really appreciate this.
So, basically my impedance calculation is correct? I mean the V/R formula for HB analysis?
now there are some doubts:
1. If I dont run the S-parameter simulation, how can I get S11(db) value?
2. I am using the formula P_Probe2[0]/dbmtow(Pin) for efficiency. Is it correct?
3. Next, what procedure should I follow for impedance matching? Smith chart utility?
4. I dint understand the comment 'HB measurements with absorbed power level in the intended range'.
Thanks in advance. I will be really very helpful if you please can help me to clear my doubts,