Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Something is wrong in your file.
It sounds like the FPGA itself if selecting that causes the crash.
The usual fix is to archive it out then in but if you cannot do that then it needs to be sent to Zuken for repair.
But that is only for maintenance customers.
So your stuffed if not on maintenence.
The only option I can see is to copy everything else that does NOT cause it to crash to a new file, save it at each section you paste in.
Use the selection tools to select board outline, every thing etc apart from the area that causes the crash then copy them.
Paste into a new design, save and ECO update it.
Then you only have the bits that caused the crash to redo.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.