Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
I want to design Mixed circuit design by using nanoscale CMOS with NEMS switch
Which one of these software can be used for simulation and layout?
Cadence layout isn't the best for MEMS structures, other tools
have been more aggressive in adding support for the weird
(from an IC perspective) geometries. And it's certainly the
most expensive tool for the job (unless this is Somebody Else's
Problem).
I've seen some other layout editors that make noise about
MEMS suitability; I'm sure you could turn them up with a
search, I forget their proper names. But my take-away was,
they were sort of weak in other aspects and of course the
PDK is the real obstacle in adopting alternative tools.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.