Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Cadence PCB signal integrity (SI)

Status
Not open for further replies.

halfblod

Newbie level 1
Joined
Jun 3, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,289
pcb signal integrity

hi everybody
i install Cadence Orcad 16.2 just for allegro PCB SI . but it dosent have it.
I dont underestand where can i find this program from cadence.
cadence orcad 16.2 dose have this program and i cant find where should must go, or it dosent have an i must DL full CadenceOrcad 16.2?
i just know that i DL the full cadence 16.2. but i cant find this.
what should i do?

i upload 2 picture to this post,
one from during installing orcad(when i sellected all product of orcad)
and one of all list of programs in Start>programs>Orcad

plz help me.
 

mikal

Member level 1
Joined
Jun 5, 2006
Messages
33
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,286
Location
Austin, TX
Activity points
1,591
cadence signal integrity

PCB SI is initiated from inside the PCB editor program. Its' a pule down, but it doesn't actually say "PCB SI".

From the PCB editor, you have to set up all the nets, power/grounds, stackup, components, etc, then initiate the program, and it will then launch sig explorer with the extracted topology of the net that's being analyzed.


-Mike
https://www.pcb-experts.com/PCB-design-services.html
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top