Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Bus configuration or wiring problem

Status
Not open for further replies.

nikhilele

Advanced Member level 3
Joined
Jan 11, 2006
Messages
805
Helped
101
Reputation
202
Reaction score
76
Trophy points
1,308
Location
Bangalore India
Activity points
6,376
I have simple doubt in bus configurations.
I know to keep more no of ground or sheilding the bus with ground gives good performance but for simple confuguration. which is the best choice
I have attached file.

I know its silly question but I also know here I will get answers.
 

Yes no3 is best for shielding. What kind of bus are you talking about pcb lines pcb layers or flat cable? In any case if the rise time is not very fast and you dont need to shield the signals from outside noise sources it will not make any difference.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top