Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Burnt Resistor value required for AL1713 LCD Monitor

Status
Not open for further replies.
Maybe I am too late with my answer, but I post it anyway.

The value of the burnt resistor R1 in the Powerboard/invertor board =

R1 = 10 ohm / 1/4 watt, but I would suggest to replace it with a resistor :

10 ohm / 1/2 watt since it is in the +5 volt line and the current may be a bit too high for a simple 1/4 watt resistor.

I will attach the service manual of this Acer monitor AL1713 to this message.

success
 
Maybe I am too late with my answer, but I post it anyway.

The value of the burnt resistor R1 in the Powerboard/invertor board =

R1 = 10 ohm / 1/4 watt, but I would suggest to replace it with a resistor :

10 ohm / 1/2 watt since it is in the +5 volt line and the current may be a bit too high for a simple 1/4 watt resistor.

I will attach the service manual of this Acer monitor AL1713 to this message.

success
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top