Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need to know, protocols or standards such as KNX and BACnet and some other ones, have been applied for which layer or layers of TCP/IP network model?
When I connected a loop of FCU's over bacnet and the end of the loop is router , y there is only two controllers does not show on router even thou when i connected the through the off line controller it connected and i can see it online but can see it on router ?
I think, modbus is most commonly used protocol in buildings. Bacnet is also used commonly. Bacnet will be most used protocol in buildings in the near future.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.