Deepon
Member level 1
Hello,
I am currently willing to design circuits using the Barkley's BSIMSOI model file. I have downloaded the verilog-A code, but during simulation in Cadence, it is asking for the values of the following parameters:
I don't know where to find the proper values of these parameters, I searched the maunal, but no use. Can anyone help me out on this? I am willing to operate it in the 45-28nm regime.
I am currently willing to design circuits using the Barkley's BSIMSOI model file. I have downloaded the verilog-A code, but during simulation in Cadence, it is asking for the values of the following parameters:
| Name | Description | Units |
| Id | Drain current | amperes |
| Ig | Gate current | amperes |
| Is | Source current | amperes |
| Ie | Substrate current | amperes |
| Ip | External body current | amperes |
| Ib | Internal body current | amperes |
| Power | Total dissipated power | watts |
| Vds | External drain-source voltage | volts |
| Vgs | External gate-source voltage | volts |
| Ves | External substrate-source voltage | volts |
| Vps | External body contact to source voltage | volts |
| Vbs | External source to internal body voltage | volts |
| Ids | Internal drain-source current | amperes |
| Ibd | Internal body-drain current | amperes |
| Ibs | Internal body-source current | amperes |
| Isub | Internal impact ionization current | amperes |
| Igidl | Internal GIDL current | amperes |
| Igs | Internal gate-source tunneling current | amperes |
| Igd | Internal gate-drain tunneling current | amperes |
| Igb | Internal gate-body tunneling current | amperes |
| Igcs | Internal gate-channel tunneling current at source side | amperes |
| Igcd | Internal gate-channel tunneling current at drain side | amperes |
| Vdsat | Drain-source saturation voltage | volts |
| Vth | Threshold voltage | volts |
| Qg | Internal gate charge | coulombs |
| Qb | Internal body charge | coulombs |
| Qd | Internal drain charge | coulombs |
| Qs | Internal source charge | coulombs |
| Gmbs | Body transconductance | siemens |
| Gm | Forward transconductance | siemens |
| Gmids | Gm/Ids | 1/volts |
| Gds | Output conductance | siemens |
| Cgg | dQg/dVgb | farads |
| Cgd | dQg/dVdb | farads |
| Cgs | dQg/dVsb | farads |
| Cbg | dQb/dVgb | farads |
| Cbd | dQb/dVdb | farads |
| Cbs | dQb/dVsb | farads |
| Cdg | dQd/dVgb | farads |
| Cdd | dQd/dVdb | farads |
| Cds | dQd/dVsb | farads |
I don't know where to find the proper values of these parameters, I searched the maunal, but no use. Can anyone help me out on this? I am willing to operate it in the 45-28nm regime.