My last post updated.
Buy two of these.
**broken link removed**
Set voltage for TTL pins to 3.3V using switch. connect one to each BT module. Plug both BT modules to PC. Note down COM port used for each BT module. Do what I said in my previous post.
Please post how you configured 2 X HC-05 to communicate with each other. I have ordered the BT modules and I will test with mikroC code.
valor=getc();
switch(valor)
{
case ('0'):
X=desactivar();
break;
case('1'):
X=activar();
break;
}
hello,
MikroC and 16F => problem ...
Show you compilng messages window result...
di you get some "IRP_bit " inside ?
means bank access problem
because this PIC has not a lot of RAM memory.
sorry, i didn't see you take care you changed to CCS !
With MikroC , if FOSC is correctly defined inside the project , i never see unaccuarte UART speed..even with internal oscillator.
and with OSCTUNE you can adjust FOSC up to + - 5 % of deviation, but not necessary at all.
Please zip and attach the complete CCS C project files so that it can be compiled and tested.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?