allan09
Newbie level 2
I am doing a project employing bluetooth module - master and slave modules=.
Is there anyone could help me how to configure this two modules to act like a simple switch (on and off) which is to be controlled by the master and the slave module would trigger 2 LEDs in the opposite end.
But in this case I won't be using a pc. The modules are set with RS232 at full duplex.
I would highly appreciate if anyone could assist me on this project.
Thank you.
Is there anyone could help me how to configure this two modules to act like a simple switch (on and off) which is to be controlled by the master and the slave module would trigger 2 LEDs in the opposite end.
But in this case I won't be using a pc. The modules are set with RS232 at full duplex.
I would highly appreciate if anyone could assist me on this project.
Thank you.