Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

basic difference between chopper and dc-dc convertor

Status
Not open for further replies.

arjune5

Newbie level 2
Joined
Sep 21, 2007
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
hello
If somebody could pls list out the differences between a DC CHOPPER and a DC-DC CONVERTOR(BUCK,BOOST,CUK ETC.) . They seem to have the same circuit diagram. Pls reply.
 

Somebody may be able to clarify, but by my understanding a DC cchopper is just a general term for such switching circuits. Whereas boost, buck, flyback converters etc are specific types of SMPS's.
 

chopper circuits are mainly for converting DC to AC using a switching terminal which is being connected to a transformer....!
 

Chopper circuits decreases voltage level of DC. It consumes the chopped voltage or just blocks it.

On the other hand, DC to DC converters first modulate DC to a high frequency sinusoidal AC voltage, then pass from a ferrite or air core transformer, and finally rectify at a different (higher or lower from the input) DC level.

Is that clear?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top