AHHA
Newbie
Dear helpers,
I am using AWR circuit.
After I defined frequency band (0.8GHz to 0.9GHz, 0.02GHz step), both in project option and circuit option,
I want co use _FREQ as an variable so I set test1=_FREQ and display test1 value by "test1:" equation.
But after analyzer, "test1:0" is shown.
I guess the _FREQ variable is not updated yet. Please recommend the way to fix this error.
Thank you!
I am using AWR circuit.
After I defined frequency band (0.8GHz to 0.9GHz, 0.02GHz step), both in project option and circuit option,
I want co use _FREQ as an variable so I set test1=_FREQ and display test1 value by "test1:" equation.
But after analyzer, "test1:0" is shown.
I guess the _FREQ variable is not updated yet. Please recommend the way to fix this error.
Thank you!