AWR MWO - Microwave Office - MATRIX syntax/definition

[deepi9or]

Hello Sirs

I'd like to do following in MWO:

I have filter with switched C. C are switched by PIN DIODES.

Vector SW is vector for ON/OFF PIN Diodes. I have 4 diodes.

So it is possible to have 2^4 combinations = 16

SW={1,1,1,1} next SW={1,1,1,0}

So I'd like to define MATRIX of SW commbinations called for exmaple X

X=
1,1,1,1
1,1,1,0
1,1,0,1
1,1,0,0
...
..
.

Than when I take X[1,*]: {1,1,1,1}

Or when I take X[3,*]: {1,1,0,1}

So than I can define SW=X[Y,*]

It means than I can sweep just over the lines and I have SW vector for settings of Diodes. Issue is that in MWO I don't know how to define/set (syntax) MATRIX X.

Target is to see S21 in the Graph for all subranges of the filter.

 

[mmicman]

Have a look at the standard example "Ideal_Phase_Shifter.emp". This has a 6-bit phase shifter, with all the equations set up. I think this demonstrates more or less what you want to do.

Good Luck!

 

[deepi9or]

Thanks a lot. I went through more or less over all examples in MWO, but this one ...