pcwortex
Junior Member level 3
I have this programator http://www.junetrading.com/product_info.php?products_id=5595 but it is problem, because I could not connect with atmega8 and atfer microcontroler.
below picture show, how I connect AVRISP programmer pin with atmega8 pin. Click on the picture and you show big size.
**broken link removed**
When I try to erase hex file to atmega8. I see this error:
**broken link removed**
AVRISP user guide http://www.equinox-tech.com/downloads/atmel/avr tools/avrisp/AVRISP_User_Guide.pdf in 10 page is write:
"Power is delivered from the target board"
maybe, need external power source delivered voltage to target bord and AVRISP programmer.
atmega8 is new and ISP frequance is 230,4 kHz.
Or maybe need external resistor about 4,7k on reset signal?
Help me connect with target bord.
below picture show, how I connect AVRISP programmer pin with atmega8 pin. Click on the picture and you show big size.
**broken link removed**
When I try to erase hex file to atmega8. I see this error:
**broken link removed**
AVRISP user guide http://www.equinox-tech.com/downloads/atmel/avr tools/avrisp/AVRISP_User_Guide.pdf in 10 page is write:
"Power is delivered from the target board"
maybe, need external power source delivered voltage to target bord and AVRISP programmer.
atmega8 is new and ISP frequance is 230,4 kHz.
Or maybe need external resistor about 4,7k on reset signal?
Help me connect with target bord.