Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[AVR] AVR Atmel Studio Jtagen Problems

Status
Not open for further replies.

Rocketman46

Member level 3
Joined
Jan 9, 2014
Messages
56
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,844
Hi all,

I am using Atmel Studio 6.2 with the Atmel ICE and I have made the mistake of unseleting the JTAGEN tick box. Anyway I programmed the MCU and I have lost all communication with the MCU now.

I have build another board and completed the below steps, but I am still having problems communication with the MCU:

Rebuild Solution >> Device Programming >> Apply >> Fuses, and "unable to program" is shown. I have not programmed the MCU yet to blow the JTAGEN on the new chip. How do I set Device Programming back to defaults?

Is it a setting in the programmer Atmel ICE that has blow, because I would of thought the new board and MCU with of sorted my JTAGEN issues?

Look forward to your reply.
 

Daniel_Arg

Newbie level 5
Joined
Dec 9, 2009
Messages
10
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
Argentina
Activity points
1,361
Whatever you did to the old board should definitely not persist in the new one. What programmer are you using?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top