Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Automatic PML Creation in Ansoft HFSS

Status
Not open for further replies.

elando

Newbie level 1
Joined
Jan 7, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,288
Dear All,

I read in an Ansoft document about PML that:

- the "Uniform Layer Thickness" should be set to be lamda/10 of the lowest frequency to be solved for (page 7 of the doc attached). Can anybody explain me which minimun frequency it is in concern here? It is the start frequency for the analysis or the minimun frequency set in the PML Wizard?

- should the minimun frequency set in the PML Wizard (page 9 of the doc attached) match the minimun frequency set in the Analysis set up (Sweep set up) of the project?

Thanks,

EL
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top