shahid78
Full Member level 5
shahid
hi
i am using cst mws to do electromagnetic anaysis and design of antenna.
i have found that the mesh used to discretize has a profound affect on the final results.
so i am wondering whether to do manual meshing or to prefer automatic meshing with adaptive mesh refinement.
i mean how much i can trust the automatic meshing results.
and in case if i run the adaptive meshing for my structure . should i take it as the final reliable result as far as the simulation is concerned
i hope people expert in simulation software may have an answer to this important question
regards
shahid
hi
i am using cst mws to do electromagnetic anaysis and design of antenna.
i have found that the mesh used to discretize has a profound affect on the final results.
so i am wondering whether to do manual meshing or to prefer automatic meshing with adaptive mesh refinement.
i mean how much i can trust the automatic meshing results.
and in case if i run the adaptive meshing for my structure . should i take it as the final reliable result as far as the simulation is concerned
i hope people expert in simulation software may have an answer to this important question
regards
shahid