Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Attenuator at 2.4GHz design help

Status
Not open for further replies.
V

vpmedina

Junior Member level 2
Joined
Nov 23, 2007
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,457
2.4 ghz attenuator

hi!

i am trying to make an attenuator at 2.4GHz

any suggestions?

will a pi/tee network work at this freq?

if yes, what will be the best type of resistor to use?

thanks!
 

Re: Attenuator at 2.4GHz

Either PI or T attenuators will work at 2.4GHz. To minimize the parasitic inductance of the resistors place two or three of them in parallel.
The type of resistors and their power dissipation is function of the RF power need to be attenuated.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top