Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ATMEL Tools (PAL/GALs) - help needed

Status
Not open for further replies.
B

BOSS

Junior Member level 1
Junior Member level 1
Joined
Feb 9, 2002
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
38
pal atmel

Please somebody could tell me if jedec files generated with ATMEL WinCUPL are compatible with every kind of devices (Lattice, *****, ...).
If not, Witch tool windows compatible can do this ?

_________________
Bye and thanks


26-03-2002
Edited by Super Moderator
For info about ***** please ask the poster. Use only e-mail.
 

H

Hero

Full Member level 2
Full Member level 2
Joined
Mar 6, 2002
Messages
145
Helped
4
Reputation
8
Reaction score
2
Trophy points
1,298
Activity points
1,608
Hi,

PALCE16V6, PALCE20V8, PALCE22V10 and GAL16V8,GAL20V8, GAL22V10 are fully JEDEC compatible.

I don't have any official proof from vendors but I didn't have any bad experience.

I think that in the past were compatibility problems with old AMD PALCE devices. These devices didn't have pull-up's on pins.

Lattice bought PLD devices from AMD and now PALCE and GAL devices are under Lattice.

I am not sure for ATMEL PLDs but I think that ATMEL use same architecture as Lattice.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top