ATMEL AT91x microcontroller troubleshooting

Status
Not open for further replies.
D

david90

Advanced Member level 1
Joined
May 5, 2004
Messages
423
Helped
9
Reputation
18
Reaction score
4
Trophy points
1,298
Activity points
3,611
microcontroller troubleshooting

I have an atmel microcontroller circuit and it is not working

I probe the XIN/XOUT lead (crystal input) but could not see a 20mhz signal on my scope.. I checked VDD and ground connector and they are good.

Is it a bad chip or is there something else I can check?

Thank you

D

Added after 22 minutes:

i changed out the crystal also
 

Check the Vdd at the pins of the chip. Check if all grounds are connected. Switch crystal if these are all good.
 

checked gnd, vdd and replaced crystal. I think for the AT91SAMX512, the main oscillator doesn't oscillate until enabled via software. Can somebody confirm this?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…