stunningbasil
Newbie level 1
With my usbtiny programmer i am not able to program atmega88 though i programmed atmega16 and attiny2313 with the same..
Its displaying device initialization error..
My programmer has 6 pin cable.. gnd,vcc,mosi,miso,rst,sck
Do i just need to connect these pins to the appropriate pins of the controller like in atmega16 or is there any other method..
PLEASE HELP..!!
Its displaying device initialization error..
My programmer has 6 pin cable.. gnd,vcc,mosi,miso,rst,sck
Do i just need to connect these pins to the appropriate pins of the controller like in atmega16 or is there any other method..
PLEASE HELP..!!