Atmega8 problem in hardware

[internetuser2k12]

I think you've not understand the problem yet. If the MCU runs it must show characters on LCD screen. Isn't it? It shows characters on LCD screen only then when I remove the "adc_rd0 = ADC_Read(0);" or similar adc conversion lines. But if "adc_rd0 = ADC_Read(0);" is written the MCU get hanged. Each of the pins (without VCC, GND and similar pins) give 2.5V. And don't show any character on LCD screen. If the adc not working then just it should show characters but can't calculate any adc value. isn't it?

I think my problem is now clear to you.

Which version of mikroC are you using? mikroC 5.6.0 or mikroC 5.6.1. See the about box of mikroC. Is it registered to P3rtic@n?

 

[Mithun_K_Das]

MicroCpro for avr v4.6

 

[tpetar]

Why you use that old version ?

 

[Mithun_K_Das]

It also doesn't work with new version. Why you can't understand that its the problem inside MCU, not in the program ?