Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Asymmetric Pattern of Quad Ridged Horn Antenna

Status
Not open for further replies.
K

K&amp#305z&amp#305

Junior Member level 3
Joined
May 19, 2010
Messages
27
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Location
Ankara / Turkey
Activity points
1,429
Hi, I have designed a quad ridged horn antenna. Everything is fine, gain, sparameters, etc. However, E-plane pattern of each port has shifted 1-2 degrees. It is because of the asymmetry of quad ridged waveguide feed section. This is caused by the phase delay due to other prob's enterance. When I use the connector having small external radius, the shift decreases. However, I should use a specific connector, therefore I need a techniques to get rid of this asymmetry.

Could you give me an advice on this issue?

Regards..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top