Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Assigning port locations in Encounter

Status
Not open for further replies.

ch1pz

Newbie level 5
Joined
Dec 1, 2006
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,350
Hi,
I am just learning to use Encounter from Cadence and was wondering if there is a way you can physically assign your port locations on the digital block? As of right now we have the port locations in the verilog code but it only applies to their order and side we want them on (left, right, top, bottom). So I just wondering if you can physically tell the program where you want the ports to be placed, like a coordinate value or something.

Thanks for your help!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top