Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

assign a schematic to a composite symbol (top level) in dxdesigner

Status
Not open for further replies.
K

klobbur

Newbie level 1
Newbie level 1
Joined
Feb 5, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
7
Hi,

I have a top level composite symbol (SDRAM) and I would like to copy the symbol and the schematic sheet because I dont want to draw everything again. Actually I have copied the block in the navigator, so I already have two schematic sheets. But when I copy the composite symbol then I have to symbols referencing to the same schematic. How do I assign the new block (schematic) to the new composite symbol?

Thanks!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top