Ruritania
Member level 5
Help: ASITIC Problems
Hi,
1. While using ASITIC to simulate inductors, when I turned on the eddy option, I kept getting the "round-off error" messages, why and how to solve this problem?
2. Why do I get the warning messages of "KCL violation"? is this warning important?
3. While modeling the transformers, how to extract the S-params from ASITIC? If the 2porttrans command can be used, then which two port does this command refer to??
Thank you,
Ruri
Hi,
1. While using ASITIC to simulate inductors, when I turned on the eddy option, I kept getting the "round-off error" messages, why and how to solve this problem?
2. Why do I get the warning messages of "KCL violation"? is this warning important?
3. While modeling the transformers, how to extract the S-params from ASITIC? If the 2porttrans command can be used, then which two port does this command refer to??
Thank you,
Ruri