Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ARM Philips 2138 ICP programmer

Status
Not open for further replies.
P

pasicr

Advanced Member level 1
Joined
Aug 13, 2005
Messages
440
Helped
39
Reputation
80
Reaction score
29
Trophy points
1,308
Location
Macedonia
Activity points
4,213
logomatic v1.0

Hi,
If somebody have experiences with connecting Logomatic V1.0 (sparkfun electronics) with LPC-ICP programmer?
I attached this two document.
On Logomatic board exist JP3 connector for connecting with LPC programmer.
My question is:
RX0 and TX0 from JP3 are going to pins 21 and 19 on ARM 2138. Where I can connect RST and BSL pin from JP3 on ARM 2138?
Instead, RST pin on ARM 2138 have own reset (pin 57), what is BSL?
Best regards
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top