ARES GND plane to pin makes a cross - but I want solid conection to GND plane

[anotherbrick]

ARES GND plane to pin makes a cross - but I want "full copper" conection to GND plane

hello dear forum

I use ARES ( Proteus 7.7 )
I have selected Inner2 layer as GND plane

as you can see in the attached picture
the GND plane to pin connection is a "cross"

however I want a " full " copper connection - sorry for my english but you understood what I mean

how can I get a full copper to pin connection ?

 

[beltec]

Re: ARES GND plane to pin makes a cross - but I want "full copper" conection to GND p

hello dear forum

I use ARES ( Proteus 7.7 )
I have selected Inner2 layer as GND plane

as you can see in the attached picture
the GND plane to pin connection is a "cross"

however I want a " full " copper connection - sorry for my english but you understood what I mean

how can I get a full copper to pin connection ?

View attachment 88937

Right click on pad, then set Relief to 'Solid'