Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

anti jam wireless modem - advice on design please

Status
Not open for further replies.

emix

Newbie level 2
Joined
Apr 20, 2003
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
13
anti jam wireless modem?

what is the way to design a wireless modem with anti jamming capability ?

some link and info about jamming methods and anti jamming for wireless system(data tx/rx) design is needed by me.

regards
 

some problems

You will have to either hop over an unusually wide part of spectrum or direct spread over it.

Here are some more pointers.

1. Use highlydirective antennas at each end.

2. Operate in part of the spectrum that you are not expected to be. In some countries this can be done at limited power levels.

3. Even with spreading methods, if the jammer is close to the receiver and it is intentional, you cannot avoid it. If they are going to be illegal with their transmissions, they will be illlegal with the power levels as well.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top