Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

annotating switching activity

Status
Not open for further replies.
M

Mamdouh

Member level 1
Joined
Feb 20, 2010
Messages
34
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,288
Location
Egypt
Activity points
1,490
when annotating switching activity to a design in DC and then reporting power I realized that both daynamic power and leakage power changed the question is why leakage power changed as i know leakage power is fixed for the cell and its value is in the library so why did it change after annotating switching activity
 

Hi,

I think it is static power....Static power has two components leakage power and Short Circuit power (due to a point both PMOS and NMOS are active). May be DC is adding this component to static power while calculating..

Regards,
Esh..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top