Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Analog Multiplexerdesign - request for resources

Status
Not open for further replies.

superluminal

Member level 4
Joined
Jan 31, 2002
Messages
79
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Location
Inside a quantum well
Activity points
806
Analog Multiplexer

Hi all

Does anyone have good materials ( papers, books , sites ...etc) or can suggest good reference ( not necessary be electronic , but prefer to ) about analog multiplexer design ?

Thanks in advance
 

Do you mean design WITH or OF analog multiplexers?
For the first case i would recommend the analog devices homepage and following papers/articles

https://www.analog.com/switch-mux

Winning the Battle Against Latchup in CMOS Analog Switches
by Catherine Redmond (catherine.redmond@analog.com)
https://www.analog.com/library/analogDialogue/archives/35-05/latchup/latchup.pdf

AN-35: Understanding Crosstalk in Analog Multiplexers (pdf, 503,802 bytes)
https://www.analog.com/UploadedFiles/Application_Notes/177696709AN35.pdf

but i think this is also usefull for the design of switches

edit: ah im sorry u posted this in the asics forum so this should be clear ;)
wheres my brain

HTH
dsp_
 

If what you mean is design OF an analog multiplexer, you can implement it by means of a series of unitary gain analog buffers, which you turn on and off using an ENABLE pin.

If I wasn't clear enough, please make me know;-)

Regards
 

Thanks for all

but I actually need more deep information about the design OF analog multiplixer . This analog mux will be responsiple for taking multiple signals from skin PH MEMS sensor & then deliver it for A/D for farther processing.
 

Well, naturally there are many things to take in account. The DAQ sampling freqency vs the MUX aperture time and the MUX charge injection. The on/off isolation ratio important for the x-talk between the DAQ channels, the ON impedance value and it's thermal dependence, the injected noise. In general it is dificult to interface a MUX directly to a sensor, because the charge injection and the load modulation due to the MUX switching may and will cause uncertainties in the sensor biasing hence the sensor dynamic range and presision will suffer. As a rule of tumb, the electronic swith component should be placed as further along the amplification chain as possible.
 

Analog Multiplexer

we need a circuit for 8 to 1 multiplexer using 3 to 8 decoder
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top