Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Analog control for a push pull converter

Status
Not open for further replies.

Optimus_prime

Newbie level 2
Joined
Jan 5, 2010
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
South Africa
Activity points
1,319
I have a push pull converter with mulptiple outputs and it is working well in open loop. I would like to close the loop by implementing voltage mode conrol. I wanted to use TL494 but the information there is inadequate. Is there any other chip I could use without going the digital route?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top