_pA89
Junior Member level 1
Hi Everyone,
Is There a way to Insert C-Code into a Model/Symbol into Altium Designer instead of SPICE Model and run Simulation ....
or at-least C Code to SPICE Converter Software...
(OrCAD Points one in that direction -Pspice-Simulink Integratoin but SIMULINK instead of C-Code)
This could be very useful (in case of Micro-controllers) and very Easy(e.g. TPS727) to {Test Integrity(Continuity) of Circuits, Put Complex Models, ...}
Procedure could be lot FASTER
P.S.: Question Might sound Naive as I am new:???: to SPICE Language ...
Is There a way to Insert C-Code into a Model/Symbol into Altium Designer instead of SPICE Model and run Simulation ....
or at-least C Code to SPICE Converter Software...
(OrCAD Points one in that direction -Pspice-Simulink Integratoin but SIMULINK instead of C-Code)
This could be very useful (in case of Micro-controllers) and very Easy(e.g. TPS727) to {Test Integrity(Continuity) of Circuits, Put Complex Models, ...}
Procedure could be lot FASTER
P.S.: Question Might sound Naive as I am new:???: to SPICE Language ...