zxcvbnmöç
Newbie
Although there is no gap in top layer and three-dimensional schemes in Altium, when I place top layer and bottom layer sheets, there is a gap.
Another question is this: I used a lot of MSTEPs for the connection between MLINs in the ADS microstrip circuit. But if I look at the layout of the circuit, no box is visible. Whether it is mstep or not, the layout is the same as below. But when I remove msteps in schematic, s parameters change. In short, I did not understand the logic of the mstep case in Altium.
Another question is this: I used a lot of MSTEPs for the connection between MLINs in the ADS microstrip circuit. But if I look at the layout of the circuit, no box is visible. Whether it is mstep or not, the layout is the same as below. But when I remove msteps in schematic, s parameters change. In short, I did not understand the logic of the mstep case in Altium.