Pont de Pedra
Junior Member level 3
Hi,
I'm using the "dcfifo" mega function, from Altera Quartus V 5.0, to design a 16550 UART in VHDL.
The FIFO works fine.
I use it in "Show-ahead synchronous FIFO mode”.
- The first time the power is on, the FIFO is empty, the output q[11...0] sends a "0" when the uControler reads it.
Right.
- Then it receives true data.
-When the FIFO has been read for 16 times (depth of the FIFO), the data shown in q[11...0] is not "0" (the FIFO is empty).
Usually it shows the last value received or random values.
It is not very important, because the FIFO marks empty, then the value in q[11...0] is not valid.
I've tried a UART from Philips and National and the value read is always “0” (if the FIFO is empty).
Anyone has encounterd this problem or something similar?
Thank's in advance.
I'm using the "dcfifo" mega function, from Altera Quartus V 5.0, to design a 16550 UART in VHDL.
The FIFO works fine.
I use it in "Show-ahead synchronous FIFO mode”.
- The first time the power is on, the FIFO is empty, the output q[11...0] sends a "0" when the uControler reads it.
Right.
- Then it receives true data.
-When the FIFO has been read for 16 times (depth of the FIFO), the data shown in q[11...0] is not "0" (the FIFO is empty).
Usually it shows the last value received or random values.
It is not very important, because the FIFO marks empty, then the value in q[11...0] is not valid.
I've tried a UART from Philips and National and the value read is always “0” (if the FIFO is empty).
Anyone has encounterd this problem or something similar?
Thank's in advance.
