Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

AGND refernce for Relay control signals!!!!

Status
Not open for further replies.

arunrajendhar

Member level 3
Joined
Dec 25, 2008
Messages
63
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
India
Activity points
1,623
Whether we give the AGND ground reference for Relay control signals?? as below

Reply me ASAP


AGND
UDB Signal
GND Plane


Thanks,
 

how can we advise you based on such little information?

Are you struggling to figure out what reference/ground to use for your signals?

What ground does the source use? what ground does the recipient of the signals use?

AFAIK Thats what defines which one to use.
 

cyberrat said:
how can we advise you based on such little information?

Are you struggling to figure out what reference/ground to use for your signals?

What ground does the source use? what ground does the recipient of the signals use?

AFAIK Thats what defines which one to use.

Thanks for the reply.

In my board the source gnd is GND but my brd contains 8 devices and the analog signals from each site get their own AGND return path like AGND1, AGND2, AGND3..etc also my brd contain lot of relays so i want to confirm that whether i give the AGND as the return path for Relay control signals..

Thanks for your help
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top