elektr0
Full Member level 5
Hello,
isnt there a possibility to parametrize rectangles, wires and polygons within agilent ADS layout tool.
I can modify the width of wires, but not the coordinates, between which it is located.
Polygons and rectangles dont give parametrization possiblities at all.
Any ideas ?
greets elektr0
isnt there a possibility to parametrize rectangles, wires and polygons within agilent ADS layout tool.
I can modify the width of wires, but not the coordinates, between which it is located.
Polygons and rectangles dont give parametrization possiblities at all.
Any ideas ?
greets elektr0