dmginc
Newbie level 1
Created a stepped-impedence LPF in ADS Momentum and am now using it as part of a larger circuit in ADS Schematic. The simulation won't start due to the error below, however, if I remove the Momentum component, simulation completes with no errors whatsoever.
What could be the cause of this error?
Any help would be greatly appreciated!!!
************************************************************
Simulation / Synthesis Messages
Error detected by hpeesofsim during analysis.
Could not find transient or envelope analysis component for cosimulation
of circuit with `filterMOM_1' and its neighbors
Status / Summary
hpeesofsim (*) 331.200 May 6 2008 (built: 05/06/08 00:26:15)
Copyright Agilent Technologies, 1989-2008.
-------------------------------------------------------------------------------
Simulation finished with errors.
-------------------------------------------------------------------------------
Resource usage:
Total stopwatch time: 0.19 seconds.
--------------------
Simulation terminated due to error.
--------------------
************************************************************
What could be the cause of this error?
Any help would be greatly appreciated!!!
************************************************************
Simulation / Synthesis Messages
Error detected by hpeesofsim during analysis.
Could not find transient or envelope analysis component for cosimulation
of circuit with `filterMOM_1' and its neighbors
Status / Summary
hpeesofsim (*) 331.200 May 6 2008 (built: 05/06/08 00:26:15)
Copyright Agilent Technologies, 1989-2008.
-------------------------------------------------------------------------------
Simulation finished with errors.
-------------------------------------------------------------------------------
Resource usage:
Total stopwatch time: 0.19 seconds.
--------------------
Simulation terminated due to error.
--------------------
************************************************************
