shouldn't you use & (and) instead of |(or) when setting config value?
hi....
i am using 20MHz crystal so what will be my A/D Acquisition Time Select bits and A/D Conversion Clock Select bits ??? i m currently using 2 Tad and Fosc/16 is it correct ???
should i use extra delay in between OpenADC() and ConvertADC() as in my program ???
hi....
i am using 20MHz crystal so what will be my A/D Acquisition Time Select bits and A/D Conversion Clock Select bits ??? i m currently using 2 Tad and Fosc/16 is it correct ???
should i use extra delay in between OpenADC() and ConvertADC() as in my program ???
What was the problem in the end?
How large is the variation?
Tahmid,
If i am giving 2.60V than output of adc will be between 2.50 to 2.70 and it varies every time. I don't understand that how it could be ? because program and hardware is correct. I am measuring voltage on multimeter and DSO. if my power supply is faulty than fault will be displayed on DSO but it's not.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?