Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Actel SmartFusion Development Kit ARM Cortex M3 - Debugging using Keil Ulink2

Status
Not open for further replies.
D

devank.purohit

Newbie level 6
Newbie level 6
Joined
Dec 5, 2012
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,373
Initially, when I tried to debug using Keil uVision ARM MDK v4.70a, there was a prompt for Firmware update. I clicked on OK and then it said Firmware Download failed. Later, the Ulink2 Debugger is being recognized; but only as an USB input device. When I tried debugging again, the error displayed is 'No JTAG Devices found'. Can somebody help me out please? Thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top