Sloko2
Newbie
Hi, I'm new to this forum and I hope you can help me on next. Forgive my English.
I have some dron transmitters these use stm8s103f3 of 20 pin. I have managed to break the reading protection in flash and eeprom (less than 5 minutes in a delicate and effective process)
Now I want to program others on the i2c bus (address 0x20) without having to perform this process. I have the flash program and Erprom but I do not know how to write in the Eeprom a few bytes to enable some extra functions.
Can you help me access the eeprom via the i2c bus?
I have some dron transmitters these use stm8s103f3 of 20 pin. I have managed to break the reading protection in flash and eeprom (less than 5 minutes in a delicate and effective process)
Now I want to program others on the i2c bus (address 0x20) without having to perform this process. I have the flash program and Erprom but I do not know how to write in the Eeprom a few bytes to enable some extra functions.
Can you help me access the eeprom via the i2c bus?