Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ac analysis setup question

Status
Not open for further replies.

diarmuid

Full Member level 2
Full Member level 2
Joined
Aug 4, 2011
Messages
143
Helped
10
Reputation
20
Reaction score
9
Trophy points
1,308
Location
Dublin, Ireland
Visit site
Activity points
2,429
Hello,

I have to do an ac analysis of an op-amp using Eldo.

I put an ac source on the input. I set the DC voltage to my DC point.

But it also has fields for Phase and Magnitude.

What do I set these at and would that be useful?

Thanks,

Diarmuid
 

Phase = 0 and mag = 1 is what I do. But you need
to "sniff" the input difference voltage to get the
right basis for loop gain (open or closed) - not the
magnitude of the stimulus source.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top