Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] about using 8051 development board

Status
Not open for further replies.
K

kaprevenugopal

Newbie level 2
Newbie level 2
Joined
Feb 5, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,291
hi,i have a project on 8051.i have installed the flash magic but not able to burn the code on the controller.The message appeared in the dialog box was"try using decreased baud rate.Reset the hardware in ISP mode".I have tried decreasing the baud rate.But still it isn't working.What should be done?????????
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top