Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If you want to make simple programmer you will need :
1. P89v51rd2
2. Max 232
3. 10uf capacitors (5) - 4 for max232(or you can use Four - 0.1uf) and one for reset circuit.
4. DB9 connector.
5. 7805(5v volt. regulator)
6. 1000uf capacitor(for power supply)
7. 12v, 1amp adaptor(and its connector for pcb)
8. 11.0592MHZ crystal oscillator for P89v51
9. 8.2k or 10k resistance.
10. 30pf capacitors (for crystal)
11. 10k pull-up resistors ( 3 pull-up, if you dont find any buy 10k resistance24)
12. headers and wires and few led's (say 10)
13. a reset switch (tack switch)
14. Usb to serial cable(if your computer dont have any serial port)
Note:
1. Dont forget to buy ic base(40 pin and 16 pin)
2. Buy DB9 connector carefully(according to your pc serial port or usb to serial cable.. Db9 - Female or male)
And Dont Forget to Buy :
1. General purpose PCB
2. soldering iron
2. solder wire
3. solder flux(paste)
4. tweezers
or Breadboard if you dont want to make it on pcb..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
