Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A8904 brushless motor controller driver [help]

Status
Not open for further replies.

bobcat1

Advanced Member level 4
Joined
Jul 10, 2002
Messages
1,288
Helped
99
Reputation
198
Reaction score
34
Trophy points
1,328
Activity points
8,547
HI

Looking for experience with the A8904 BLDC controller.

My motor dose not have CENTER tap required for the BEMF connected to PIN 10

Can I connect a 3 phase motor without the center tap - how to do it?

Should i add a BEMF comperator stage for detecting the zero-cross BEMF signal?

Any one hase some advice or for working experience with that chip?

Any one has software rotuine for programming and operating the chip?


Thanks in advance

Bobi
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top