8051 & AVR Evaluation Board design help

[oister]

Evaluation Board!!!!!!

Can nyone provide good material on

''Design of evaluation board for 8051 and avr mcu'c".

Its my final year project so please help me out how to start.

 

[nandhu015]

Evaluation Board!!!!!!

8051 and AVR mcu are different

You can do any one and not both

Nandhu

 

[kender]

Re: Evaluation Board!!!!!!

You can do any one and not both

Why not? Oister could make one board with 2 largely separate section for each of the controllers. At least, they could share power. I agree that from industrial standpoint it doesn't make a lot of sense to use 2 controllers with similar capabilities from 2 different families. But it's an academic (undergraduate?) project, so it doesn't necessarily have to make a lot of sense.

 

[blueroomelectronics]

Evaluation Board!!!!!!

Well at least it's not a...
UPS
SMS remote control
Traffic light
Pedestrian counter

Or any other LAMEO final year project.

 

[oister]

sorry this is my project title:
Design of an Evaluation Board for 8051 & AVR MCU’s within ISP Interface

now where to start?

 

[nandhu015]

As far as i know 8051 (at89c51) and avr(atmega8535) have same pin configuration.

Nandhu

 

[Alphan]

I have lots of project about 8051 and AVR, pls provide your e-mail, I will send to you for reference. do you need hardware information or software (only c code)?

 

[nandhu015]

I have lots of project about 8051 and AVR, pls provide your e-mail, I will send to you for reference. do you need hardware information or software (only c code)?

Why dont you post it here? If you want to contact him personally use pm

Nandhu

 

[boseji]

sorry this is my project title:
Design of an Evaluation Board for 8051 & AVR MCU’s within ISP Interface

now where to start?

I have developed a small board for the AT89C51 as well as P89V51RD2.
The schematics is attached.

Send me a PM in case you want to know more.

Warm Regards,
Boseji
https://m8051.blogspot.com

 

[oister]

i want to know how to start it step by step....