Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How low of an Rds on do you think you need? To get much below 1 ohm, you're looking at expensive technology, like SiC. For such high voltages, conduction losses probably won't even dominate, so you might look at fast IGBTs as well. Or just using a different topology that requires less voltage handling.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
