5-Phase Stepper Motor

[Aaron36]

Hi everyone,
I recently got my hands on an Emco PCTurn 50 with 5-phase stepper motors. After some careful consideration, I decided to use them instead of converting to a 2-phase motor. My question is, how do I isolate the phases so I can connect them? There are 2 sets of 5 connectors and I only need 5 wires to connect to the drive.
Any help would be greatly appreciated.

 

[FvM]

Not sure what you mean with "isolate"? If your motor has separated windings (10 wires in total) and the controller 5 terminals, the motor wires are connected pair-wise.