[AVR] 433Mhz Tx&RX with atmega8

[MuhammadAbubakar]

Dear PEople.
I am having a problem.I am sending a stream of data from one uC ATmega8 to an other and at the receiver end I am viewing this data on my PC using FTDI chip.
The problem is the ADC values which I am sending are being correctly received on my Receier but when I try to map those ADC values to the PWM pins they dont work properly. I dont know how to convert those Char Values to int for PWM.
Plz help
Thanks.

 

[b0j3]

Isn't the AnalogWrite (https://arduino.cc/en/Reference/analogWrite) enough?

 

[MuhammadAbubakar]

No. As I told you i am not using Arduino.
I am Using Atemga8 as Tx and RX.
the values received are OK but when I try to apply those values on PWM pins, The O/P of PWM dosent behave Properly.

 

[b0j3]

Aha... sorry. I was too much in Arduinos
Does this site help? https://sites.google.com/site/qeewiki/books/avr-guide/pwm-atmega8
I am planning to play with ATMEGA16 and I can look at it at that time (if you don't find solution ).

 

[welove8051]

i think for atmega8 adc is 10bit and pwm is 8bit.