Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

4:1 coax cable balun

Status
Not open for further replies.
G

guanxiaolong

Newbie level 3
Joined
Aug 31, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,304
图片1.png
Hi,everyone,In this picture,we can see the PA circuit board.The input port has a balun with transformer (4:1) using a ferrite,and the output has the 4:1 coax cable transformer and the coax cable balun. The frequency is 50MHz to 75MHz. I have two question for your help, thank you very much.
The first question is about the balun with transformer (4:1) using a ferrite in the input port. How to make it in particular requirement, for example,how to choose the ferrite, how to match the tansistor input impedance,50/4=12.4 is rigth for the transistor(FREESCALE MRFE6VP61K25H).
The second question is about the 4:1 coax cable transformer and the coax cable balun in the output port. How to calculate the length and the impedance of the coax cable.
Thanks,wish you good luck.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top